100K Thermistor Types and the Sprinter/Marlen firmware values

Chris Anderson/ August 15, 2014/ Uncategorized/ 2 comments

Configuring Marlin and Sprinter firmware It is important to select to correct thermistor values in you 3D printer firmware setting in order to get proper temperature readings an therefore get good prints.   In order to do this both Marlin and the Sprinter firmwares used by RepRap 3D printers have pre-defined Thermistor indexes.  As a user you only need to select

Read More

Filament lengths – 3D Printing

Chris Anderson/ August 12, 2014/ Uncategorized/ 0 comments

Filament Lengths based on 1 KG roll PLA Density: 1.25 g/cm^3 Volume: 0.80 cm^3/g or 800 cm^3/kg 1.75 mm filament length for 1 kg spool: ~ 330 meters / ~ 1080 feet 3.00 mm filament length for 1 kg spool: ~ 110 meters / ~ 360 feet ABS Density: 1.04 g/cm^3 Volume: 0.96 cm^3/g or 960 cm^3/kg 1.75 mm filament

Read More

Howto recompile raspbian kernel for touch panel AT070TN92 V.5

Chris Anderson/ July 18, 2014/ Uncategorized/ 0 comments

In order to get the Raspberry Pi to recognize the touchscreen on 7 inch display – see other artical need to compile in needed drivers This is related to the following Post For touch panel is called AT070TN92 V.5 Taken from – http://o2t1.blogspot.de/2013/02/raspberry-pi-howto-recompile-raspbian.html Raspberry Pi – Howto recompile raspbian kernel At first, i use Fedora. You can download Fedora here and start the

Read More

OLED LCD LED Display Module for Arduino

Chris Anderson/ July 18, 2014/ Uncategorized/ 0 comments

This OLED part No is UG-2864HSWEG01 not UG-2864AMBAG01 Needn’t  backlight, the display unit can self-luminous High resolution: 128 * 64 Viewing angle: >160 ° Supports many control chip: Fully compatible with Arduino, 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc. Ultra-low power consumption: full screen lit 0.08W Voltage: 3V ~ 5V DC Working Temperature: :-30℃~70℃ Module Size: 27.0MM *

Read More