100K Thermistor Types and the Sprinter/Marlen firmware values

Chris Anderson/ August 15, 2014/ Uncategorized/ 2 comments

Configuring Marlin and Sprinter firmware It is important to select to correct thermistor values in you 3D printer firmware setting in order to get proper temperature readings an therefore get good prints.   In order to do this both Marlin and the Sprinter firmwares used by RepRap 3D printers have pre-defined Thermistor indexes.  As a user you only need to select

Read More

OLED LCD LED Display Module for Arduino

Chris Anderson/ July 18, 2014/ Uncategorized/ 0 comments

This OLED part No is UG-2864HSWEG01 not UG-2864AMBAG01 Needn’t  backlight, the display unit can self-luminous High resolution: 128 * 64 Viewing angle: >160 ° Supports many control chip: Fully compatible with Arduino, 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc. Ultra-low power consumption: full screen lit 0.08W Voltage: 3V ~ 5V DC Working Temperature: :-30℃~70℃ Module Size: 27.0MM *

Read More

SainSmart 3.2″ TFT LCD Display with touch screen module for Arduino Mega2560

Chris Anderson/ July 17, 2014/ Uncategorized/ 0 comments

Description TFT LCD Display is a LCD touch screen module. It has 40pins interface and SD card and Flash reader design. It is a powerful and mutilfunctional module for your project.The Screen include a controller SSD1289, it’s a support 8/16bit data interface , easy to drive by many MCU like STM32 ,AVR and 8051. It is designed with a touch

Read More