About Chris Anderson

Site owner

Ubuntu Setup on Windows 10 with oh-my-zsh and oh-my-vim

Chris Anderson/ March 5, 2018/ Uncategorized/ 0 comments

Install Ubuntu for windows Install the Linux subsystem Start Powershell as administrator and run the following command – reboot will occur after command is finished After reboot install Ubuntu using the Microsoft Store – search “ubuntu” and select install. Open Ubuntu console for the first time – follow prompts to configure console/ubuntu for the first time. Perform APT update/upgrade after

Read More

DIY Remzibi OSD Open Source GPS for FPV System – 2013 NEW Version

Chris Anderson/ February 8, 2015/ Uncategorized/ 0 comments

DIY Remzibi OSD Open Source V1.79 5HZ GPS for Quadcopter FPV System 2013 NEW Version This is a 2013 latest version, optimized the output lines, all replaced by silica gel line, integrated step-down circuit to the mainboard, optimized the plug, so that it is more easy to use. The 2013 version not included external BEC step-down circuit, has been integrated

Read More

Repetier-Host start/stop gcode for TAZ

Chris Anderson/ September 7, 2014/ Uncategorized/ 0 comments

Here is my Repetier-Host start and stop gcode settings that I am using for my home built TAZ.  Using these settings in the new Cura Engine slicer – love it!  These commands can be used on other printers with some minor tweaks.  Key features is the system does not zero the Z axis on x/y 0/0 but moves a little

Read More

100K Thermistor Types and the Sprinter/Marlen firmware values

Chris Anderson/ August 15, 2014/ Uncategorized/ 2 comments

Configuring Marlin and Sprinter firmware It is important to select to correct thermistor values in you 3D printer firmware setting in order to get proper temperature readings an therefore get good prints.   In order to do this both Marlin and the Sprinter firmwares used by RepRap 3D printers have pre-defined Thermistor indexes.  As a user you only need to select

Read More