Featured post

Ubuntu Setup on Windows 10 with oh-my-zsh and oh-my-vim

Chris Anderson/ March 5, 2018/ Uncategorized/ 0 comments

Install Ubuntu for windows Install the Linux subsystem Start Powershell as administrator and run the following command – reboot will occur after command is finished After reboot install Ubuntu using the Microsoft Store – search “ubuntu” and select install. Open Ubuntu console for the first time – follow prompts to configure console/ubuntu for the first time. Perform APT update/upgrade after

Read More

DIY Remzibi OSD Open Source GPS for FPV System – 2013 NEW Version

Chris Anderson/ February 8, 2015/ Uncategorized/ 0 comments

DIY Remzibi OSD Open Source V1.79 5HZ GPS for Quadcopter FPV System 2013 NEW Version This is a 2013 latest version, optimized the output lines, all replaced by silica gel line, integrated step-down circuit to the mainboard, optimized the plug, so that it is more easy to use. The 2013 version not included external BEC step-down circuit, has been integrated

Read More

Repetier-Host start/stop gcode for TAZ

Chris Anderson/ September 7, 2014/ Uncategorized/ 0 comments

Here is my Repetier-Host start and stop gcode settings that I am using for my home built TAZ.  Using these settings in the new Cura Engine slicer – love it!  These commands can be used on other printers with some minor tweaks.  Key features is the system does not zero the Z axis on x/y 0/0 but moves a little

Read More